Introduction4
1.1Concerned Hardware4
2Range of Test5
2.1Work Flow5
2.2Typographic Convention6
3Conditions before Starting6
3.1General6
3.2Supported APZ Source Systems7
4Test Tools7
5General8
5.1Schematic Overview – APG439
5.2APG43 Board Positions11
5.2.1BSC Board Configuration with APZ 212 5511
5.2.2CN Board Configuration with APZ 212 5512
5.2.3CN Board Configuration with APZ 212 6013
5.3Board Information of eGEM with APG43 and APZ 212 55/6014
5.4APG43 Architecture16
5.5APG43 Cabling for Magazine with APZ 212 55 or APZ 212 6017
6Method19
6.1Preparation19
6.1.1Board Positions19
6.1.2Cabling19
6.1.3Check the Strap Connectors19
6.1.4Power Up19
6.1.5Connect to the APG4319
6.2Check Resources and Installed Clone Image20
6.2.1Checking State of Cluster Resources20
6.2.2Checking GPO22
6.2.3Checking Replication23
6.2.4Modify Registry Setting25
6.2.5Checking Installed Clone Image26
6.3APG43 Backup Verification27
6.4Definition of HWC29
6.4.1Definition of the Boards29
6.4.2Check Master/Slave relationship35
6.5Configuration of SMO37
6.6Prepare for Site Parameter Change40
6.6.1Name Rules and Recommendation41
6.6.2Check Current Site Parameters42
6.6.3Check the RAID47
6.7Parameter Change54
6.7.1General54
6.7.2Pre CloConfig Steps54
6.7.3CloConfig Steps55
6.7.4Post CloConfig Steps57
6.8Configure APG43 for APZ61
6.8.1STS Setting61
6.8.2TFTP Setting62
6.8.3MAS Setting63
6.8.4ACS Setting