Configure 2 carriers per sector in RNC and RBS using one or two MCPA per sector on RBS

slavicp51，一定要把目录粘贴出来！！！

一、Add 2nd Carrier procedure at Site.doc
二、add Carrier RBS.pdf---23页
1、Introduction
2、Accessing the RBS
3、Adding Baseband Capacity
3.1 Overview
3.2 Deleting an RAX Board
3.3 Installing a Board
3.4 Adding a Board to the Configuration
4、Adding an ET Board
5、Adding a Sector
6、Extending Cell Range
7、Adding a Carrier
8、Dual-Band Expansion
9、Adding Additional PSU
10、Performing Concluding Routines
三、add Carrier RNC.pdf--117页
1、Introduction
2、Overview of the RN Configuration
3、Configuring the Nodes
4、Configuring the CnOperator MO
5、Configuring the Areas
6、Configuring the WCDMA Carrier Frequencies
7、Configuring the Cells
8、Configuring the Channels
9、Configuring a GSM Network
10、Configuring the Multi-Operator Core Configuring the Multi-Operator Core
11、Reconfiguring the DCH Frame Synchronization
12、Reconfiguring the Radio Connection
13、Configuring the Synchronization towards the RBS
14、Configuring the IubEdch
15、Configuring the NBAPs
16、Configuring the RNSAP
17、Configuring the RANAP
18、Configuring a Cell Relation
19、Configuring UE Positioning
20、Configuring A-GPS Positioning
21、Configuring a PDR
22、Configuring a Device Group, Device Set, and Device
23、Related Documents

[ 本帖最后由 laomaoyixin 于 2009-4-25 22:47 编辑 ]